Whirlpool washer is loud on the spin cycle

[Appliance Repair Guy]

I have a Whirlpool WTW5000DW3 washer (bought new in 2021) that’s loud on the spin cycle with no vibrations. Not banging or out of balance, just a little louder than normal on the spin cycle.

Do I run it this way until it dies or do I repair it?

 

[Hefty_Heron3067]

If it's just louder but still spinning fine, it could be early wear on the drive hub or pulley which is common on this model. Running it like that won't hurt short-term, but if the noise gets worse or you notice performance issues.

 

[Deleted member 128]

If it's just louder but still spinning fine, it could be early wear on the drive hub or pulley which is common on this model. Running it like that won't hurt short-term, but if the noise gets worse or you notice performance issues.

try to turn the tub with hands (no water,no cloth) should tur smouthly.if there is noise abnormal
problem with the bearing assembly. bearing comes with the gearcase(expensive)

 

[george09]

My sister's got the same model and it's been quiet, so your post caught my eye. Is the noise more of a whine or a rumble? I've heard worn bearings or a loose pulley can cause that without shaking. Did it start suddenly or get louder over time?